[libvirt] [perl PATCH] Post-release version bump to 1.3.0

[Pavel Hrdina]

Signed-off-by: Pavel Hrdina <phrdina at redhat.com>
---
 Makefile.PL     | 2 +-
 README          | 2 +-
 lib/Sys/Virt.pm | 2 +-
 3 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/Makefile.PL b/Makefile.PL
index 709be83..4ae538f 100644
--- a/Makefile.PL
+++ b/Makefile.PL
@@ -3,7 +3,7 @@ use ExtUtils::MakeMaker;
 # See lib/ExtUtils/MakeMaker.pm for details of how to influence
 # the contents of the Makefile that is written.
 
-my $libvirtver = "1.2.21";
+my $libvirtver = "1.3.0";
 my $stat = system "pkg-config --atleast-version=$libvirtver libvirt";
 die "cannot run pkg-config to check libvirt version" if $stat == -1;
 die "libvirt >= $libvirtver is required\n" unless $stat == 0;
diff --git a/README b/README
index 757d652..a942d66 100644
--- a/README
+++ b/README
@@ -7,6 +7,6 @@ further details on libvirt consult its website http://libvirt.org/
 The only pre-requisite for this module is libvirt itself. For
 installation instructions, consult the INSTALL file.
 
-The current minimum required version of libvirt is 1.2.21
+The current minimum required version of libvirt is 1.3.0
 
 -- End
diff --git a/lib/Sys/Virt.pm b/lib/Sys/Virt.pm
index 0371d08..9e7c6d9 100644
--- a/lib/Sys/Virt.pm
+++ b/lib/Sys/Virt.pm
@@ -78,7 +78,7 @@ use Sys::Virt::NWFilter;
 use Sys::Virt::DomainSnapshot;
 use Sys::Virt::Stream;
 
-our $VERSION = '1.2.21';
+our $VERSION = '1.3.0';
 require XSLoader;
 XSLoader::load('Sys::Virt', $VERSION);
 
-- 
2.6.3