[Libvirt-cim] 'Parsing error' during make postinstall step of installing libvirt-cim

[U Gopalakrishnan]

Hi Kaitlin,

I followed the instructions in the wiki, postinstall step is now 
completing without a make error. But I see few error messages in the 
output. I think most of them are harmless and is because the postinstall 
step is run multiple times. 
But one particular error message given below is worrying me.

Parsing error: parse error: Error adding class Xen_HostedResourcePool to 
the repository: CIM_ERR_INVALID_SUPERCLASS: CIM_HostedResourcePool

The complete output from the 'make postinstall' command is attached. 

Please advise on whether these error messages needs to be looked into or 
could be safely ignored.

Also, the README contained in the source tar.gz files found at 
ftp://libvirt.org/libvirt/CIM/ seems to be outdated, e.g. it didn't 
mention about the make preinstall step. May be README could just give a 
link to the wiki page which seems to be current.

Thanks
Gopal






Kaitlin Rupert <kaitlin at linux.vnet.ibm.com> 
Sent by: libvirt-cim-bounces at redhat.com
01/14/2009 23:27
Please respond to
List for discussion and development of libvirt CIM 
<libvirt-cim at redhat.com>


To
List for discussion and development of libvirt CIM 
<libvirt-cim at redhat.com>
cc

Subject
Re: [Libvirt-cim] 'Parsing error' during make postinstall step of 
installing libvirt-cim






U Gopalakrishnan wrote:
> 
> Hello,
> 
> I am trying to setup latest libvirt-cim in RHEL 5.2 with Pegasus server 
> 2.8.0-1.  I am using libvirt-cim source snapshot dated 01/13/09 obtained 

> from ftp://libvirt.org/libvirt/CIM/ .
> Following the README in the source, the 'make postinstall' step fails 
> with the following error.
> 

> Registering providers with active cimserver
> Parsing error: parse error: Could not find declaration for Qualifier 
> named ASSOCIATION
> make: *** [postinstall] Error 250
> 

Hi Gopal,

This error looks like the Pegasus repository isn't setup properly. 
Before running make postinstall, did you run "make preinstall"?  After 
running make preinstall, you'll need to restart Pegasus.

Not sure if you've looked at this, but there's some instructions at: 
http://wiki.libvirt.org/page/Libvirt-cim_setup

Let us know if this doesn't resolve the issue.

-- 
Kaitlin Rupert
IBM Linux Technology Center
kaitlin at linux.vnet.ibm.com

_______________________________________________
Libvirt-cim mailing list
Libvirt-cim at redhat.com
https://www.redhat.com/mailman/listinfo/libvirt-cim

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://listman.redhat.com/archives/libvirt-cim/attachments/20090115/6d00c394/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: postinstall.out
Type: application/octet-stream
Size: 34479 bytes
Desc: not available
URL: <http://listman.redhat.com/archives/libvirt-cim/attachments/20090115/6d00c394/attachment.obj>