[libvirt-users] Checking if the VM has been created

[Till Mossakowski]

Am 16.11.2011 14:46, schrieb William A. Mahaffey III:

> The route command on the host will show the newly added routes for the
> VM. Also, tail your syslog file & you will see messages about every 15
> min. from dnsmasq w/ the IP adder. of the VM.

route just shows the bridge, the individual IP of the VM is only shown 
in the syslog. However, this is just a workaround, and does not provide 
reliable identification of the IP if there are many VMs. libvirt resp. 
virsh should provide a way of obtaining the IP directly from the domain 
name.

Best, Till


-- 
Prof. Dr. Till Mossakowski  Cartesium, room 2.51 Phone +49-421-218-64226
DFKI GmbH Bremen                             Fax +49-421-218-9864226
Cyber-Physical Systems                      Till.Mossakowski at dfki.de
Enrique-Schmidt-Str. 5, D-28359 Bremen   http://www.dfki.de/sks/till

Deutsches Forschungszentrum fuer Kuenstliche Intelligenz GmbH
principal office, *not* the address for mail etc.!!!:
Trippstadter Str. 122, D-67663 Kaiserslautern
management board: Prof. Wolfgang Wahlster (chair), Dr. Walter Olthoff
supervisory board: Prof. Hans A. Aukes (chair)
Amtsgericht Kaiserslautern, HRB 2313