[libvirt-users] libvirt on armhf with selinux driver
Michal Privoznik
mprivozn at redhat.com
Mon Jan 13 15:50:24 UTC 2014
On 13.01.2014 16:10, Ivan Gooten wrote:
> hi,
>
> recently i've been busy with libvirt(d) v1.2.0 on armhf and i see, even
> if selinux sec driver is enabled on the configure stage, the driver is
> not finally created. these configure parameters are:
>
> --with-selinux
> --with-secdriver-selinux
> --with-selinux-mount=/sys/fs/selinux
>
> the /sys/fs/selinux is valid, selinux is running in permissive mode, got
> also libselinux DEV package installed, so no missing req. headers here.
>
> when trying to run libvirtd, i'm getting:
>
> error : virSecurityDriverLookup:78 : unsupported configuration: Security
> driver selinux not enabled
> error : lxcSecurityInit:1461 : Failed to initialise security drivers
> error : virStateInitialize:854 : Initialisation of LXC state driver
> failed: unsupported configuration: Security driver selinux not enabled
> error : daemonRunStateInit:909 : Driver state initialisation failed
>
> someone got any clue what may be causing this?
>
> thanks,
> ivan gooten
>
Are you sure selinux is enabled? Not enforcing, just enabled.
Michal
More information about the libvirt-users
mailing list