[Linux-cluster] innactive nodes after cluster installation
fausto
tinuscubensis at gmail.com
Fri Dec 10 20:39:50 UTC 2004
Hi there,
We are trying to setup a two-nodes cluster using clumanager. After add
the two member to the cluster and create the rawdevices, all the
member are inactived, the clustat's output is:
Cluster Status - mail-cluster 15:04:38
Incarnation #0
(This member is not part of the cluster quorum)
Member Status
------------------ ----------
192.168.0.151 Inactive
192.168.0.152 Inactive <-- You are here
No Quorum - Service States Unknown
-------------------------------------------------------------------
Both member have access to the shared raw partition in the storage,
here is the clurawtest's output:
Starting exercises...
1 iterations run in 0 days, 00:00:05
Write Exercise Passes: 1
* 269 successful writes
Read Exercise Passes: 3
* 621 successful reads
* 617 successful data integrity checks
Overall result: Pass
-------------------------------------------------------------------
and these are the entries in message:
Dec 10 15:06:33 atmail-1 clumanager: cluquorumd startup succeeded
Dec 10 15:06:33 atmail-1 cluquorumd[6347]: <warning> STONITH: No
drivers configured for host '192.168.0.151'!
Dec 10 15:06:33 atmail-1 cluquorumd[6347]: <warning> STONITH: Data
integrity may be compromised!
Dec 10 15:06:33 atmail-1 cluquorumd[6347]: <warning> STONITH: No
drivers configured for host '192.168.0.152'!
Dec 10 15:06:33 atmail-1 cluquorumd[6347]: <warning> STONITH: Data
integrity may be compromised!
At this time we don't have any service created just the two cluster's member.
Any idea?
Regards,
fausto
More information about the Linux-cluster
mailing list