[Linux-cluster] supported switch list?

[Lazar Obradovic]

On Wed, 2004-10-20 at 16:19, Lazar Obradovic wrote:
> fence_sanbox2 has been tested on SANBox2 8 and SANBox2 16 switches. It
> uses CLI (telnet) for accessing switch. It uses "admin start" and "set
> port <portnumer> state offline/online" commands. If SANBox 5200 uses the
> same syntax / procedure for bringing the port down/up, it'll work for
> you. 

I've just checked manual pages for SANBox2-64 and SANBox 5200, and they
should work fine with fence_sanbox2, but I would very much like you to
test it and let us know the results.

-- 
Lazar Obradovic, System Engineer
----- 
laza at YU.net
YUnet International http://www.EUnet.yu
Dubrovacka 35/III, 11000 Belgrade
Tel: +381 11 3119901; Fax: +381 11 3119901
-----
This e-mail is confidential and intended only for the recipient.
Unauthorized distribution, modification or disclosure of its
contents is prohibited. If you have received this e-mail in error,
please notify the sender by telephone +381 11 3119901.
-----