[Linux-cluster] fence_sanbox2 configuration example?
Dan B. Phung
phung at cs.columbia.edu
Tue May 31 22:17:15 UTC 2005
Can somebody who's using the fence_sanbox2 agent let me take a peek at
their config?
here's what I have so far for fencedevices:
<fencedevices>
<fencedevice name="human" agent="fence_manual"/>
<fencedevice name="san" agent="fence_sanbox2"
ipaddr="fsm.cs.columbia.edu" login="foo" passwd="bar"/>
</fencedevices>
is the port indicated in the manpage the WWN for the host bus adaptor?
-n port
The port number to disable on the switch.
here's what I think I should have in each clusternode entry:
<clusternode name="blade01" nodeid="1" votes="1">
<multicast addr="224.0.0.1" interface="eth0"/>
<fence>
<method name="fibre">
<device name="san" port="2100000d55d32ced"/>
</method>
<method name="single">
<device name="human" port="128.59.18.1"/>
</method>
</fence>
</clusternode>
and to test this, I was going to suddenly turn off networking
for the blade and see how the rest of the cluster reacts.
-dan
--
More information about the Linux-cluster
mailing list