[Linux-cluster] Packet loss after configuring Ethernet bonding

[Digimer]

On 11/09/2012 09:26 PM, Zama Ques wrote:
> Hi All, 
> 
> Need help on resolving a issue related to implementing High Availability at network level . I understand that this is not the right forum to ask this question , but since it is related to HA and Linux , I am asking here and I feel somebody here  will have answer to the issues I am facing .
> 
> I am trying to implement Ethernet Bonding , Both the interface in my server are connected to two different network switches . 
> 
> My configuration is as follows: 
> 
> ========
> # cat /proc/net/bonding/bond0
> 
> Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)
> 
> Bonding Mode: adaptive load balancing Primary Slave: None Currently 
> Active Slave: eth0 MII Status: up MII Polling Interval (ms): 0 Up Delay 
> (ms): 0 Down Delay (ms): 0
> 
> Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link 
> Failure Count: 0 Permanent HW addr: e4:e1:5b:d0:11:10 Slave queue ID: 0
> 
> Slave Interface: eth1 MII Status: up Speed: 1000 Mbps Duplex: full Link 
> Failure Count: 0 Permanent HW addr: e4:e1:5b:d0:11:14 Slave queue ID: 0
> ------------
> # cat /sys/class/net/bond0/bonding/mode 
> 
>   balance-alb 6
> 
> 
> # cat /sys/class/net/bond0/bonding/miimon
>    0
> 
> ============
> 
> 
> The issue for me is that I am seeing packet loss after configuring bonding .  Tried connecting both the interface to the same switch , but still seeing the packet loss . Also , tried changing miimon value to 100 , but still seeing the packet loss. 
> 
> What I am missing in the configuration ? Any help will be highly appreciated in resolving the problem . 
> 
> 
> 
> Thanks
> Zaman

You didn't share any details on your configuration, but I will assume
you are using corosync.

The only supported bonding mode is Active/Passive (mode=1). I've
personally tried all modes, out of curiosity, and all had problems. The
short of it is that if you need more that 1 gbit of performance, buy
faster cards.

If you are interested in what I use, it's documented here:

https://alteeve.ca/w/2-Node_Red_Hat_KVM_Cluster_Tutorial#Network

I've used this setup in several production clusters and have tested
failure are recovery extensively. It's proven very stable. :)

-- 
Digimer
Papers and Projects: https://alteeve.ca/w/
What if the cure for cancer is trapped in the mind of a person without
access to education?