[Linux-cluster] Tripp Lite PDU

[Erik Dorthe]

Marek,

This is the agent I wrote. I have not done a man page or perldoc for it,
but it is documented in the comments.

Regards,
Erik Dorthé
NOC Engineer
CARI.net
858.974.5080 x217
edorthe at cari.net
<http://www.cari.net/>


On Mon, Feb 11, 2013 at 10:23 AM, Marek Grac <mgrac at redhat.com> wrote:

> On 02/11/2013 05:36 PM, Erik Dorthe wrote:
>
>> I know there has been an agent submitted for this before (see link at the
>> bottom of this email), but I created an agent for the Tripp Lite SNMP
>> Management Card. This agent uses SNMP to issue commands to a Tripp Lite
>> PDU. I have found that some of the limitations mentioned in the past do not
>> seem to exist anymore, which may be a result of a firmware update (I am
>> using version 12.06.0061).
>>
>> The primary limitation was a delay in the power state change, which had
>> taken up to 35 seconds in the past. I have found no delay over 10 seconds,
>> which improves response time significantly.
>>
>> I have put this agent into testing in a prototype cluster, and my initial
>> results look good. The model I am testing with is a PDUMH20ATNET. If anyone
>> would like to look over the agent or review it for inclusion, please
>> contact me.
>>
> Sure, please resend agent to me
>
> m,
>
> --
> Linux-cluster mailing list
> Linux-cluster at redhat.com
> https://www.redhat.com/**mailman/listinfo/linux-cluster<https://www.redhat.com/mailman/listinfo/linux-cluster>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://listman.redhat.com/archives/linux-cluster/attachments/20130211/b8405162/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: fence_tripplite_snmp
Type: application/octet-stream
Size: 6343 bytes
Desc: not available
URL: <http://listman.redhat.com/archives/linux-cluster/attachments/20130211/b8405162/attachment.obj>