[Ovirt-devel] host not shown in default hardware pool

[Ingmar Schraub]

Hello,

I am new to ovirt and please bare with me if my question has been asked
before. I googled, studied the wiki and searched the bug list. But I
couldn't find anything similar.

I've just set up a new server with F10, fully patched and installed
ovirt using the Rawhide build instructions.

All seems to work nicely, but I am stuck at one point.

After 'sudo ovirt-install-node-stateful' followed by a host reboot I
started the appliance again. My problem is that the host is not shown at
all in the default hardware pool. Any hints what's going wrong here?
What could be missing that the appliance doesn't see my host?
Networking, bridge, etc. is all ok.

I had also to tweak /etc/httpd/conf.d/ovirt-server.conf because the
ovirt-appliance httpd doesn't start with the config file provided. There
is already a ticket open on bugzilla. (#489819).

Thanks a lot in advance.

regards,

Ingmar