[Ovirt-devel] [PATCH node] Fixes the messages after running any configuration option.
Darryl L. Pierce
dpierce at redhat.com
Mon Feb 23 22:00:14 UTC 2009
Previously, if any script had a 0 return code, o-c-setup would say it
ran successfully. This was confusing, especially when the user aborted.
So now o-c-setup shows nothing until the script exited with a non-zero
error code. All scripts already reported success, failure and abort
messages, so no other changes were really needed.
Signed-off-by: Darryl L. Pierce <dpierce at redhat.com>
---
scripts/ovirt-config-setup | 2 +-
scripts/ovirt-config-storage | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/scripts/ovirt-config-setup b/scripts/ovirt-config-setup
index 4fcc212..69b279b 100755
--- a/scripts/ovirt-config-setup
+++ b/scripts/ovirt-config-setup
@@ -42,7 +42,7 @@ while true; do
clear;
{
if $CONFIG_DIR/*"$OPTION" ; then
- printf "\n$OPTION Completed Successfully\n\n"
+ printf "\n"
else
printf "\nERROR: $OPTION FAILED. "
printf "See $OVIRT_LOGFILE\n\n"
diff --git a/scripts/ovirt-config-storage b/scripts/ovirt-config-storage
index c29f99c..18b9e0c 100755
--- a/scripts/ovirt-config-storage
+++ b/scripts/ovirt-config-storage
@@ -503,7 +503,7 @@ else
"Configure") do_configure ; break ;;
"Review") do_review ; break ;;
"Partition") do_confirm ; break ;;
- "Quit") exit ;;
+ "Quit") printf "\nExiting.\n"; exit ;;
esac
done
done
--
1.6.0.6
More information about the ovirt-devel
mailing list