[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: phoebe3 install (network KS) problem



Jeremy Katz wrote:
On Wed, 2003-02-19 at 18:07, William Jon McCann wrote:

It seems to correctly identify the network card but then I get the following message in console 4:
<131>Feb 19 17:44:45 loader: failed to set default route: Network is unreachable


My ks.cfg file contains the following:
#Use static networking
network --bootproto static --ip 128.220.XXX.XXX --netmask 255.255.0.0 --gateway 128.220.XXX.XXX --nameserver 128.220.XXX.XXX
where the XXX have actual values.


This has worked in previous releases. Anyone have any ideas?


For now, add --device eth0.  Fixed internally post the freeze for these
bits.



I'm still unable to get the installer to configure the network. Is there some diagnostic tool that I can use?


Are there any updated boot disk images available?

Should I file a bug? Would this go under anaconda?

Thanks,
Jon





[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]