[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: Can't activate /dev/st0



Look at the contents of /proc/scsi/scsi, and /proc/scsi/*/* to find your
tape drive.  Here's what I get:

# cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
  Vendor: ARCHIVE  Model: Python 04106-XXX Rev: 735B
  Type:   Sequential-Access                ANSI SCSI revision: 02

HTH

-Michael

>>> dsavage peaknet net 03/11/03 10:58PM >>>
On Tuesday March 11, 2003 Erik Burke wrote:
> Hi there. I recenmtly had the same type of issue with an HP
SureStore
> DLT 80 drive. What I had to do was 'rmmod ide-scsi', then 'modprobe
> st'. I do that in the /etc/rc.d/rc.local file so it does it every
time
> it boots. With that my drive is now recognized and I can use it.
Hope
> this helps a bit or gives you an idea.

Erik,

No joy. Here's the modules.conf built during the install. Is there
anything missing?

   alias parport_lowlevel parport_pc
   alias scsi_hostadapter ncr53c8xx
   alias eth0 eepro100
   alias sound-slot-0 cs46xx
   post-install sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -L
>/dev/null 2>&1 || :
   pre-remove sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -S
>/dev/null 2>&1 || :
   alias usb-controller usb-uhci

And I don't know if this is significant, but I've noticed this in
dmesg:

   kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno =
2

--Doc Savage
  Fairview Heights, IL





-- 
Psyche-list mailing list
Psyche-list redhat com 
https://listman.redhat.com/mailman/listinfo/psyche-list





[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]