SCSI Tape Drive - LUN Support
Darryl W. DeLao Jr.
ddelao at oucpm.org
Wed Aug 25 13:44:08 UTC 2004
Hello everyone,
I recently installed an Adaptec SCSI Card in my PowerEdge 2650. Attached to
the Adaptec card is 1 DLT VS160 Drive. When I fire up the server, the SCSI
BIOS loads and detects everything perfectly. When RHEL ES 3.0 loads, it
does not see the DLT Drive. When I do a lsmod from the command line, I see
my RAID and the CD-ROM drive listed. Upon checking the /etc/modules.conf
file I see the following listed:
alias eth0 e1000
alias eth1 tg3
alias eth2 tg3
alias scsi_hostadapter aacraid
alias usb-controller usb-ohci
alias scsi_hostadapter1 aic7xxx
Upon doing a modprobe aic7xxx from the command line, I see this after doing
cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: DELL Model: PERCRAID RAID5 Rev: V1.0
Type: Direct-Access ANSI SCSI revision: 02
Host: scsi1 Channel: 00 Id: 00 Lun: 00
Vendor: TEAC Model: CD-224E Rev: K.9A
Type: CD-ROM ANSI SCSI revision: 02
Host: scsi2 Channel: 00 Id: 06 Lun: 00
Vendor: QUANTUM Model: DLT VS160 Rev: 1E00
Type: Sequential-Access ANSI SCSI revision: 02
The DLT is now listed and I am now able to fire up the software and use the
DLT. However, now I can not use the CD-ROM drive. I am unable to mount it
or anything. When I reboot, everything resets and I have to modprobe
aic7xxx again in order to use the DLT. Does anyone know what I need to do
or enable or what not so that I can use both the CD-ROM and the DLTVS160
after a reboot without having to issue a command to use the DLTVS160?
Thanks,
Darryl
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://listman.redhat.com/archives/redhat-install-list/attachments/20040825/23d3ac3c/attachment.htm>
More information about the Redhat-install-list
mailing list