eth0 nw interface problem

[digvijoy Chatterjee]

On Tue, 2005-06-21 at 15:30, Navin SONI wrote:
> hello all,
> 
> i recently installed RH9.0 on my new HP-Proliant DL145G2 Server.
> 
> But the system eth0 interface is not coming up.if i do 
> 
> ifconfig -a command,only lo0 interface comes up.
> 
> i tried doing ifconfig eth0 up also,but it says no such device.
> 
> the network card is "Broadcom Netxtreme ethernet BCM5721"
> 
> 
> Any help in this regard would be apprecible.
> 
> thanks
> navin.
> 
> _______________________________________________
> Redhat-install-list mailing list
> Redhat-install-list at redhat.com
> https://www.redhat.com/mailman/listinfo/redhat-install-list
> To Unsubscribe Go To ABOVE URL or send a message to:
> redhat-install-list-request at redhat.com
> Subject: unsubscribe


> mostly redhat 9.0 wont have a driver for ur card try using RHEL-3 or Fedora core 2,3,4


DigZ
Core Solutions Group
Linux|Psychedelic Rock|Death


**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***