redhat-list Digest, Vol 4, Issue 1

[Michael Sullivan]

Ok I think I understand, but I don't know which IP address is which. 
Outside the router I have a static IP address set up with the ISP.  It's
inside the router that I have problems.  Outside the router our address
here is 68.15.193.18, but inside the address of the server PC that needs
the static address is 192.168.1.4  I need to make sure that all mail and
http requests are sent there.  There wasn't a man file for ifcfg-eth0. 
How would I set this up?



> Message: 7
> Date: Mon, 31 May 2004 13:31:27 -0400
> From: "Larry Brown" <larry.brown at dimensionnetworks.com>
> Subject: RE: Setting RH9 for static IP
> To: "General Red Hat Linux discussion list" <redhat-list at redhat.com>
> Message-ID:
> 	<CBECIONKKLMDDCIKHALJAEMDLGAA.larry.brown at dimensionnetworks.com>
> Content-Type: text/plain;	charset="iso-8859-1"
> 
> ex for /etc/sysconfig/network-scripts/ifcfg-eth0
> 
> DEVICE=eth0
> BOOTPROTO=static
> BROADCAST=192.168.1.255
> IPADDR=192.168.1.6
> NETMASK=255.255.255.0
> NETWORK=192.168.1.0
> ONBOOT=yes
> 
> just replace the addresses with the static address assigned you from your
> ISP.
> 
> -----Original Message-----
> From: redhat-list-bounces at redhat.com
> [mailto:redhat-list-bounces at redhat.com]On Behalf Of Stephen Kuhn
> Sent: Monday, May 31, 2004 12:17 PM
> To: General Red Hat Linux discussion list
> Subject: Re: Setting RH9 for static IP
> 
> 
> On Tue, 2004-06-01 at 02:13, Michael Sullivan wrote:
> > I have a PC with RH9 installed on it, but because the hard drive is so
> > small, I only did a server install on it.  My network receives DHCP
> > addresses from the router.  It's thunderstorm season here in Oklahoma,
> > and when the power goes off the router gets reset, along with all the
> > DHCP addresses.  I was wondering if I could set up the server PC to
> > always have the same address and not use DHCP, because if the power goes
> > off in the middle of the night while we're asleep, we don't get our mail
> > and people can't get to the website until I fix it in the morning.  If
> > XFree86 was installed, I would just use neat, but there wasn't room for
> > XFree86.  What file do I need to edit to set the server PC to always use
> > the same local IP?
> >
> > -Michael Sullivan-
> 
> /etc/resolv.conf
> /etc/sysconfig/network
> /etc/sysconfig/network-scripts/eth0-conf
> 
> stephen kuhn - owner
> ==============================
> illawarra computer services
> a kuhn media australia company
> http://kma.0catch.com
> ------------------------------------------------------------------
>   * This message was composed on a 100% Microsoft free computer *
>   We expressly refuse to utilise Microsoft DRM encoded documents
> ------------------------------------------------------------------
> Your sister swims out to meet troop ships.
> 
> 
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list