[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: 2 NICs configuration problem

As mike suggested make entry in ifcfg-eth1
as follow:

[root baroda root]# cat /etc/sysconfig/network-scripts/ifcfg-eth1


----- Original Message -----
From: Denham Eva
To:  "Redhat-List (E-mail)" <redhat-list redhat com>
Sent: Tue, 23 Mar 2004 12:09:54 +0200
Subject: 2 NICs configuration problem

Hello list,

To begin with my knowledge on network related subjects is.. er lacking?

Anyway I have this old pc Pentium 200 MMX, 64MB ram. I installed Redhat 9 (Shrike), no X server
etc. Later I installed two Network Cards.

The idea is to create a "gateway" or should that be "router"? Also the idea is to study up on the
networking stuff.
Configuration something like this...
eth0 and eth1 on it's own subnet, hope I am clear enough so far:-)

Well after much reading up etc, I used redhat-config-network to configure eth0.
This it "sees" at startup fine, but eth1 it does not.
I then run 
ifconfig eth1 netmask broadcast
Then eth1 is available, now I don't know for how long it will remain available, I have only booted
the machine to see if it won't boot recognizing both NICs, because I can't figure out how to get
the info to "stick" so that it will startup at boot.

Apologies for the long winded mail, but
Does anyone know how I can fix this? OR
Direct me to a Howto which guides one through a similar setup?

Best Regards
Denham Eva

redhat-list mailing list
unsubscribe mailto:redhat-list-request redhat com?subject=unsubscribe

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]