How to force kudzu to look for hardware changes at boot up

[James D. Parra]

Thanks.  Since there is already a Perc3 SCSI adapter installed would the new
entry in /etc/module.conf conflict with it?

<snip>
probeall scsi_hostadapter megaraid
<snip> 

By the way, didn't know that only RH users could use this list; especially
since Mandrake is based on the RedHat distro. Regardless, I use both distros
and subscribe to many of the valuable Linux lists out there. Nor do I want
to start a flame war either, but this list tends to have solid, practical
answers. Therefore, here I am.

Thanks again,   

James 

-----Original Message-----
From: Jason Dixon [mailto:jason at dixongroup.net]
Sent: Saturday, May 22, 2004 2:46 PM
To: General Red Hat Linux discussion list
Subject: Re: How to force kudzu to look for hardware changes at boot up


On May 22, 2004, at 5:19 PM, James D. Parra wrote:

> Hello,
>
> Added a SCSI card to our server and I'd like Kudzu to add the card and
> detect the tape drive that is connected to it during boot up.
>
> The tape drive is detected by the SCSI controller at boot up (on the 
> right
> channel), but it doesn't appear as a device in harddrake.
>
> I don't mind setting it manually, if need be.

Add the following to your /etc/modules.conf:

alias scsi_hostadapter advansys

P.S.  This is a Red Hat list, not a Mandrake list.

--
Jason Dixon, RHCE
DixonGroup Consulting
http://www.dixongroup.net



-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list