How to move whole RH9 to another hard-disk?

[Yin Ming]

Must I mknod for /dev/tty* manually?

On Thu, 18 Nov 2004 14:17:31 +0800
Yin Ming <yinming at mdc-ds.com> wrote:

> Hi, all
> 
> I recently bought a new hard-disk, to replace the old one. But I got
> some problems during moving the whole system to this new hard-disk.
> 
> The old hardwares are:
> ide 0 master:	QT HD win98
> ide 0 slave:	CDROM
> ide 1 master:	MX HD RH9
> 
> The BIOS boots from the hd1(the ide 1 master MX HD), then GRUB on this
> disk's MBR. then the kernel and system which were both in the single
> partition of MX HD.
> 
> Now, I pluged the new ST HD on ide 0 master, replacing the old QT HD,
> and I'm going to use it as the system disk, and the MXHD as the backup
> disk.
> 
> ide 0 master:	STHD RH9
> ide 0 slave:	CDROM
> ide 1 master:	MX HD data backup
> 
> To do this moving, I mount the STHD in /mnt/st, then copied all the
> files ( except /dev, /proc and /mnt etc. ) to /mnt/st, the STHD, then I
> installed the GRUB on STHD's MBR via:
> root (hd0,1) #the linux root partition on STHD
> setup (hd0)
> quit
> 
> And edited grub.conf and fstab to appropriate devices. Then reboot, but
> got a failure before the kernel's calling to init, I mean, after initrd
> finished, it printed out something like "Cann't get an initial console "
> then halt...
> 
> Another problem is the GRUB on this new disk cannot use the graphic mode
> to display splash screen. My monitor got black if I enable the splash in
> grub.conf. I think it's relative to the "cann't get an initial console"
> problem.
> 
> Strange, it worked fine on the old MXHD, and this new disk hasn't any
> bad sectors. How to move whole system to another disk? I don't want to
> reinstall all the stuff... Help.
> 
> -- 
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list