FC4: Manually configure networking?

[Devon Harding]

For some reason, this doesn't seem to work on FC4.  When I run
system-config-network and configure Ethernet or when I edit my
/etc/sysconfig/network-scripts/ifcfg-eth0 file, the IP address doesn't come
up on boot, just the interface.

/etc/sysconfig/network-scripts/ifcfg-eth0
# Please read /usr/share/doc/initscripts-*/sysconfig.txt
# for the documentation of these parameters.
USERCTL=no
PEERDNS=yes
IPV6INIT=no
GATEWAY=10.10.11.252
TYPE=Ethernet
NETMAST=255.255.255.0
IPADDR=10.10.11.70
DEVICE=eth0
ONBOOT=yes

On 12/5/05, Ali Erdinç Köroğlu <erdinc at prosoft.com.tr> wrote:
>
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Hi,
> You can use GUI or you can edit /etc/sysconfig/network-scripts/ifcfg-eth0
>
> On Mon, 5 Dec 2005 12:35:09 -0500
> Devon Harding <devonharding at gmail.com> wrote:
>
> > How can I manually configure networking on an FC4 server after
> > installation?  Steps?
>
> - --
> Regards
> Ali Erdinç Köroglu
> http://www.prosoft.com.tr
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.4.1 (GNU/Linux)
>
> iD8DBQFDlHyll+k9K746qXcRArOBAKCopEGYKRSgXLxkQnRIpf/h5IKczwCguRyP
> c5cmJcmSPjB/dTRpCvpVWH4=
> =ANw4
> -----END PGP SIGNATURE-----
>
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list
>