Xwindow corrupt

[Qi, Xlaoyan]

Right after I run up2date and install packages (gdk-pixbuf,gdk-pixbuf-devel,gdk-pixbuf-gnome,gtk2,gtk2-devel)this morning, the Xwin corrupts. 
I am not sure whether it is caused by libgd since I manually installed libgd on /usr/local).  

Please help. Thanks,

Xiaoyan

-----Original Message-----
From: redhat-list-bounces at redhat.com [mailto:redhat-list-bounces at redhat.com] On Behalf Of Cecilio Marín
Sent: Monday, October 10, 2005 9:19 AM
To: General Red Hat Linux discussion list
Subject: Re: mirroring the whole disk


Anze Vidmar escribió:

> 1) OK, now I'm wondering how to setup GRUB loader, so if I disconnect 
> the 1st hdd (in case it fails) the other can take the control.

This links with a question about labels of the past week. You can configure Grub references to LABELS, not partitions. Grub will start up root partition with LABEL /, and boot with label /boot, not will depends with the disk. To build it, is better make soft raids on installation time.

>
> 2) And the other question: Let's say I've successfully booted from the 
> second disk and I've inserted a new blank disk in place of 1st (dead) 
> hdd. How to rebuld the mirror?

mdadm --manage /dev/md0 --remove /dev/hda1
mdadm --manage /dev/md1 --remove /dev/hda2
mdadm --manage /dev/md2 --remove /dev/hda3
- extract bad disk, and add new good drive
mdadm --manage /dev/md0 --add /dev/hda1
mdadm --manage /dev/md1 --add /dev/hda2
mdadm --manage /dev/md2 --add /dev/hda3

The raid remakes auto the mirror. You can see the state at /proc/mdstat

>
> I'm using FC4, but I'm sure it's the same thing with EL4 that I will 
> be using in the future.
>
> Regards,

equal

>
> Anze
>

-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list