Tape drive support again

[Allen, Jack]

	That is what I was looking for. Hopefully the 2.6 version works the
same. I will find out as soon the HBA and tape drive get hooked up.

Thanks:
	Jack Allen

-----Original Message-----
From: Dege, Robert C. [mailto:robert.dege at ngc.com] 
Sent: Wednesday, September 21, 2005 6:57 PM
To: General Red Hat Linux discussion list
Subject: RE: Tape drive support again



I use the Adaptec 39160 on one of my file servers.  The aic7xxx.ko does
support it.  I am using the 2.4 kernel on my server, although I don't
think that'll make a difference for the 2.6 series.


Excerpt from dmesg:

scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
        <Adaptec 3960D Ultra160 SCSI adapter>
        aic7899: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs

scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
        <Adaptec 3960D Ultra160 SCSI adapter>
        aic7899: Ultra160 Wide Channel B, SCSI Id=7, 32/253 SCBs


Excerpt from lspci:

01:00.0 SCSI storage controller: Adaptec AHA-3960D / AIC-7899A U160/m
(rev 01)
        Subsystem: Adaptec AHA-3960D U160/m
        Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 7
        BIST result: 00
        I/O ports at d400 [disabled] [size=256]
        Memory at ff8fe000 (64-bit, non-prefetchable) [size=4K]
        Expansion ROM at ff8a0000 [disabled] [size=128K]
        Capabilities: [dc] Power Management version 2

01:00.1 SCSI storage controller: Adaptec AHA-3960D / AIC-7899A U160/m
(rev 01)
        Subsystem: Adaptec AHA-3960D U160/m
        Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 10
        BIST result: 00
        I/O ports at d800 [disabled] [size=256]
        Memory at ff8ff000 (64-bit, non-prefetchable) [size=4K]
        Expansion ROM at ff8c0000 [disabled] [size=128K]
        Capabilities: [dc] Power Management version 2


-Rob
 

> -----Original Message-----
> From: redhat-list-bounces at redhat.com 
> [mailto:redhat-list-bounces at redhat.com] On Behalf Of Allen, Jack
> Sent: Wednesday, September 21, 2005 6:47 PM
> To: 'Redhat-list at redhat.com'
> Subject: Tape drive support again
> 
>         We are installing a Dell 6850 and loading RH AS 4. 
> Dell is telling use we need an Adaptec 39160 HBA to connect 
> the tape drive to.
> Doing "strings aic7xxx.ko | grep 160" show 29160 and 19160 
> but no 39160.
> My question is which driver supports this HBA? 
> 
> Thanks: 
>         Jack Allen 
> 
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list
> 

-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list