iLO port on HP Proliant DL560 running RedHat

[Shelton, Darren]

There is also an rpm that you can install called hponcfg that will let you
grab a config from the ilo, you can even reconfigure the ilo with hponcfg to
reset credentials if necessary.

darren

-----Original Message-----
From: redhat-list-bounces at redhat.com [mailto:redhat-list-bounces at redhat.com]
On Behalf Of Frank Ng
Sent: Thursday, February 23, 2006 4:56 PM
To: General Red Hat Linux discussion list
Subject: Re: iLO port on HP Proliant DL560 running RedHat

Rebooting the box and go press F8 to go into the ilo config menu will get
you that.

If rebooting is not an option and you know the subnet of the ilo, set your
laptop to nic with an IP on that subnet and connect your laptop with a
crossover cable to the iLo and then ping the broadcast address ...

ping 10.1.10.255

replace 10.1.10. with the subnet of your ilo.

OR

there is a tool that comes with newer iLos that you can connect to the ilo
port and it temporary overwrites the settings of your ilo and you can access
it with 192.168.1.1 to go in and check/change the settings.

OR

run a port scanner on the ilo subnet and check for port 80 AND 443, the ilos
run on both of those ports.

-fng


On 2/23/06, Ken Rossman <rossman at columbia.edu> wrote:
>
> We have lost track of the IP addresses assigned to iLO (network console)
> ports on some of our HP Proliant DL560 servers.  Is there a tool we can
> use while running under regular RedHat timesharing to obtain the current
> IP address settings for the iLO ports?
>
> Thanks in advance,
> KR
>
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list
>
-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list