Kudzu cannot detect 2nd network card
Oluwagbega Shobowale
gshobowale at nextworksltd.com
Wed Mar 29 15:31:47 UTC 2006
I think you should check if the network card is functional if it is
check that the slot if working also.
Then do your test again
-----Original Message-----
From: redhat-list-bounces at redhat.com
[mailto:redhat-list-bounces at redhat.com] On Behalf Of Ong Ying Ying
Sent: Wednesday, March 29, 2006 4:16 PM
To: redhat-list at redhat.com
Subject: Kudzu cannot detect 2nd network card
I am using Redhat 7.1 (Seawolf), Linux ver 2.4.2-2.
I have 2 network cards in my computer but kudzu detected 1
card only. Why? ifconfig showed eth0 and lo only.
Then, I setup 2 interface in Network Configurator in X-Win
and reboot. Kudzu still didn't detect and 'modprobe: Can't
locate module eth1' at Bringing up eth1.
eth1 cannot be activated on startup but it can be activate
in X but cannot save.
So how do I configure the other network card? Both the
network cards are the same. Network Configuration in Text
Mode Setup can enter 1 IP only. dmesg shows 1 network card only.
Thanks in advance.
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
More information about the redhat-list
mailing list