Some help with qla2300 driver at boot time

[Callahan, Tom]

You need to use mkinitrd to rebuild your ramdisk image.
  
Tom Callahan
TESSCO Technologies
Desk: (410)-229-1361
Cell: (410)-588-7605
Email: callahant at tessco.com


A real engineer only resorts to documentation when the keyboard dents on the
forehead get too noticeable.

-----Original Message-----
From: redhat-list-bounces at redhat.com [mailto:redhat-list-bounces at redhat.com]
On Behalf Of Bliss, Aaron
Sent: Monday, November 27, 2006 8:58 AM
To: General Red Hat Linux discussion list
Subject: Some help with qla2300 driver at boot time

Hi everyone,
I'm not sure what's happening here, however for some reason a redhat 3
ES box doesn't load the qla2300 driver at boot time (which of course
means any drives that are on the san don't get mounted); lsmod shows
that the qla2300 driver isn't loaded; running modprobe qla2300 when the
box is up and I can see all the drives on the san.  Any ideas?  Thanks.

Aaron

Confidentiality Notice:
The information contained in this electronic message is intended for the
exclusive use of the individual or entity named above and may contain
privileged or confidential information.  If the reader of this message is
not the intended recipient or the employee or agent responsible to deliver
it to the intended recipient, you are hereby notified that dissemination,
distribution or copying of this information is prohibited.  If you have
received this communication in error, please notify the sender immediately
by telephone and destroy the copies you received.


-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list