Top only displays 1 CPU

[Sean McGlynn]

If you toggle "1" to select viewing multiple cpus, and then use the W command to write to the config file, each time you start top it will start displaying the multiple cpus.  This is probably what was done on your existing boxes.


----- Original Message ----
From: "McDougall, Marshall (FSH)" <Marshall.McDougall at gov.mb.ca>
To: General Red Hat Linux discussion list <redhat-list at redhat.com>
Sent: Tuesday, April 17, 2007 3:20:39 PM
Subject: Top only displays 1 CPU


Recently I started to install some new Intel servers(both blade and 2U)
using RHEL4U4.  When I run top, I only get a single line displayed for
CPU.  With all my version 3 (2.4) boxes I get however many cpu's that
are reported at startup.  I cannot find any reference to the change of
top's behavior.  Can anyone point me to a doc or explain the new
display?  Is there a way to see what my individual CPU's are actually
doing?  Thanks.

Regards, Marshall
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com