[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

RE: RHEL 64 bit installation

Hello Geofrey,

	Probably u can have a look into adaptec scsi drivers provided in
http://www.adaptec.com/en-US/downloads according to ur scsi card. U may
get a .img version of driver so that u can use it as a floppy image.
While installation of RHEL pass the driver through floppy with "linux
dd" boot 

	Hope it helps !


-----Original Message-----
From: redhat-list-bounces redhat com
[mailto:redhat-list-bounces redhat com] On Behalf Of geofrey rainey
Sent: Tuesday, July 10, 2007 4:11 AM
To: redhat-list redhat com
Subject: RHEL 64 bit installation


I have a 64 bit architecture machine with an MS 9161 mainboard which has
an Adaptec 7901x on-board scsi controller. 

An RHEL5 32-bit installation procedure does not detect the scsi devices
so I install onto an internal IDE device. I've tried the following
methods to get the kernel to recognise the scsi devices after this
I download the kernel source file "kernel-2.6.18-8.el5.src.rpm" from
redhat - this matches the installed kernel, I then recompile the kernel
with the following drivers compiled into the kernel (not LKM's):
1. Adaptec AACRAID
2. Adaptec AIC79xx U320 support
(both listed under low-level device drivers). 
Following the recompile, and reboot into the new kernel, the kernel
still cannot see the devices.

Interestingly if I do the same thing as above but instead of using a
Redhat kernel I use the standard and most recent kernel.org kernel, it
works only if the drivers are compiled into the kernel. As LKM's the
devices are not recognised after I manually load the modules.
However, a 64 bit install of RHEL5 neither recognises the drives during
install, nor after a recompile (using the same kernel.org kernel as
above) either as LKM's or compiled into the kernel itself.
I have checked the contents of the initrd image on disc 1 of the RHEL 5
iso's, and confirmed the image does contain the AIC7xxx drivers for this
device, therefore the install should pick up the device I would have
thought and recompilation should not actually be necessary.
I do not understand why neither the initrd image during install, nor a
new Redhat kernel with the drivers compiled into it do not see the

Geofrey Rainey.
For more information on the Television New Zealand Group, visit us
online at tvnz.co.nz 
CAUTION:  This e-mail and any attachment(s) contain information that
is intended to be read only by the named recipient(s).  This information
is not to be used or stored by any other person and/or organisation.

redhat-list mailing list
unsubscribe mailto:redhat-list-request redhat com?subject=unsubscribe

[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]