Configuring RAID device at install time and after

[Bliss, Aaron]

You'll need to use mdadm for this...

Aaron 

-----Original Message-----
From: redhat-list-bounces at redhat.com
[mailto:redhat-list-bounces at redhat.com] On Behalf Of Dave Martini 1
Sent: Friday, May 04, 2007 5:19 PM
To: General Red Hat Linux discussion list
Subject: Configuring RAID device at install time and after

When installing RHEL 4 you can setup RAID devices 0, 1, 5 etc.
Is it possible to do this after the system is already installed?
Is it possible to modify a RAID device that was setup at install time 
after the system is up?

I noticed system-config-lvm but this doesn't seem to be it????

Thank You.
Dave Martini
LLNL

-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list


Confidentiality Notice:
The information contained in this electronic message is intended for the exclusive use of the individual or entity named above and may contain privileged or confidential information.  If the reader of this message is not the intended recipient or the employee or agent responsible to deliver it to the intended recipient, you are hereby notified that dissemination, distribution or copying of this information is prohibited.  If you have received this communication in error, please notify the sender immediately by telephone and destroy the copies you received.