NIC Teaming

[Aggarwal Vivek-Q4997C]

Hi Gerrard

There are 2 ports Eth0 and Eth1. Cables from both the ports are
connected to D-Link single switch (non-manageable). When I plug out the
cable from port 0 ping stops working
Regards
Vivek Aggarwal

-----Original Message-----
From: redhat-list-bounces at redhat.com
[mailto:redhat-list-bounces at redhat.com] On Behalf Of Gerrard Geldenhuis
Sent: Thursday, March 27, 2008 4:29 PM
To: General Red Hat Linux discussion list
Subject: RE: NIC Teaming

Hi Vivek,
I am assuming you bring up eth1 before shutting down eth0.

How are you shutting down the ports?

Have a look at /proc/net/bonding/bond0 which will tell you a bit more
about the current state of the bond.

It might be a network problem... are both cables plugged into the same
switch? If you are using cisco switches then spanning tree port fast
must be on.

Regards

> -----Original Message-----
> From: redhat-list-bounces at redhat.com [mailto:redhat-list-
> bounces at redhat.com] On Behalf Of Aggarwal Vivek-Q4997C
> Sent: 27 March 2008 10:52
> To: General Red Hat Linux discussion list
> Subject: RE: NIC Teaming
> 
> Hi Gerard
> 
> Thanks for the information.
> 
> I am running one problem, ping is running when both eth0 and eth1
ports
> are up but as soon as Eth1 port is shut ping is running. But its not
> working when eth0 port is shut
> 
> Can you help me in this
> 
> Regards
> Vivek Aggarwal

-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list