[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: xen vm not keeping date/time properly





Northrup, Wilson wrote:
Hello,
Have you or are you using the tickless kernel with this setup, and does
that make a difference?

> wilson
>

I don't believe so. I'm using the standard RHEL 5 installation for bot the host and guest, nothing fancy.




-----Original Message-----
From: redhat-list-bounces redhat com
[mailto:redhat-list-bounces redhat com] On Behalf Of Ryan Golhar
Sent: Thursday, January 22, 2009 2:45 PM
To: General Red Hat Linux discussion list
Subject: Re: xen vm not keeping date/time properly



George Magklaras wrote:

Ryan Golhar wrote:
9.2.2.2 says xen just passed the time-related calls to Dom0, but that

can't be the case because the times are different.

That is because if you do run ntpd inside the VM, this can create the problem.

noselect?  inside the VM?

Yes on the guest system, and run ntpd normally on the Dom0.


I'm running ntpd normally on the host, and ntpd inside the VM using the noselect parameter on the server line, such as:

server siriusc.umdnj.edu	noselect
server 0.rhel.pool.ntp.org	noselect
server 1.rhel.pool.ntp.org	noselect
server 2.rhel.pool.ntp.org	noselect

After about a half hour after restarting the ntpd server inside the guest, I'm noticing clock skew of about 30 seconds. I'm sure this will continue to grow.

Anyone have any other ideas?

I'm surprised there isn't a solution to this. This is a huge problem, especially for an enterprise system that relies on the date/time being correct.

Ryan


We are running on a Sun SunFire X4150.
What I stated was on a Dell 2950 PowerEdge, but I shall get hold of a SunFire and repeat the test, see if I get the same issue. It does
state
that there might be some kernel parameters that need tweaking, but, I
am
curious to find out what's going on, as we will be using SunFire kit with Xen soon.

GM

George Magklaras wrote:
This page might offer some help:


http://support.ntp.org/bin/view/Support/KnownOsIssues#Section_9.2.2.

To recap, we use the 'noselect' keyword to avoid the running ntpd on

the client to attempt to sync with the defined servers and ntpq does

not report any disturbing drifts on the client...and we do run ntpd normally (no 'noselect') on Dom0.

What happens (happened if you have already tried) if you try and do this? And what's your hardware platform?

GM

Notice:  This e-mail message, together with any attachments, contains
information of Merck & Co., Inc. (One Merck Drive, Whitehouse Station,
New Jersey, USA 08889), and/or its affiliates (which may be known
outside the United States as Merck Frosst, Merck Sharp & Dohme or
MSD and in Japan, as Banyu - direct contact information for affiliates is
available at http://www.merck.com/contact/contacts.html) that may be
confidential, proprietary copyrighted and/or legally privileged. It is
intended solely for the use of the individual or entity named on this
message. If you are not the intended recipient, and have received this
message in error, please notify us immediately by reply e-mail and
then delete it from your system.



[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]