scsi_id
Thomas Fess
dfezz1 at yahoo.com
Tue Sep 8 18:56:32 UTC 2009
If that is the case, then you may need to use an HP controller command to retrieve the WWID or install HP controller software, somethin similar to powerpath or ECC for EMC
________________________________
From: Edson Marquezani Filho <edsonmarquezani at gmail.com>
To: General Red Hat Linux discussion list <redhat-list at redhat.com>
Sent: Tuesday, September 8, 2009 1:42:51 PM
Subject: Re: scsi_id
On Tue, Sep 8, 2009 at 13:40, <m.roth at 5-cent.us> wrote:
>> I am not sure which scsi device you are searching for , but you should see
>> an sda, sdb type number. So when querying for the wwid of the interal
>> disk, use that descriptor.
>> such as:
>>
>> scsi_id -g -u -s /block/sda (instead of /dev/cciss/c0d0)
> <snip>
> What are you running this on - that /dev/cciss/c0d0 sure looks like
> Solaris to me, not Linux.
>
> mark
>
Singles disks or disk arrays with HP Controllers (like Smart Array
e200i) appears like this on Linux. At least with all HP Proliants I
have seen so far.
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
More information about the redhat-list
mailing list