how to setup a RHEV hypervisor using RHEL

[ESGLinux]

Hi,

Thanks for your answer,

I have done what you told and I get the host, but I get an error in the
/var/log/vdsm/vdsm.log

MainThread::ERROR::2010-10-06 19:20:19,630::ksm::28::vds::failed to find
kksmd thread

and the host is in status "Non Responsive"

What I have to do now to get the node up???

Thanks again,

ESG


2010/10/6 Vincent Van der Kussen <Vincent.VanderKussen at btr-services.be>

> Hi,
>
> Just go to the RHEV Manager and add the host. It needs to be subscribed to
> the right channels.
> Once added in the RHEV Manager, the host will be automatically installed as
> a hypervisor host.
>
> Regards,
> Vincent
>
>
> Vincent Van der Kussen
> System Engineer
> direct: +32 3 369 01 93
> Vincent.VanderKussen at btr-services.be
>
> BTR Services
> Groene Hofstraat 31
> 2850 Boom
> Belgium
> www.btr-services.be
> tel: +32 3 450 89 80
> fax: +32 3 450 89 89
>
>
>
> - DISCLAIMER -
> This message contains confidential information and is intended only for
> redhat-list at redhat.com. If you are not redhat-list at redhat.com, you should
> not disseminate, distribute or copy this e-mail. Please notify
> Vincent.VanderKussen at btr-services.be immediately by e-mail if you have
> received this e-mail by mistake and delete this e-mail from your system.
> E-mail transmission cannot be guaranteed to be secure or error-free as
> information could be intercepted, corrupted, lost, destroyed, arrive late or
> incomplete, or contain viruses. Vincent Van der Kussen therefore does not
> accept liability for any errors or omissions in the contents of this
> message, which arise as a result of e-mail transmission. If verification is
> required please request a hard-copy version.
> --------------------------------------------------------------------------
>
> ________________________________________
>
> From: redhat-list-bounces at redhat.com [redhat-list-bounces at redhat.com] On
> Behalf Of ESGLinux [esggrupos at gmail.com]
> Sent: Wednesday, October 06, 2010 5:53 PM
> To: General Red Hat Linux discussion list
> Subject: how to setup a RHEV hypervisor using RHEL
>
> Hi all,
>
> I´m trying to use a RHEL 5.5 as hypervisor but I can´t get it,.
>
> I have followed the
> doc
> Red_Hat_Enterprise_Virtualization_for_Servers-2.2-Installation_Guide-en-US.pdf
> but I can´t get the server in the RHEV Manager
>
> When I install a standalone hypervisor automatically I get the host
> registered in the RHEV Manager, but with RHEL I don´t get it and I don´t
> know how to register it.
>
> Anyone know how to do it?
>
> Thanks in advance
>
> ESG
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list
>
>
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request at redhat.com?subject=unsubscribe
> https://www.redhat.com/mailman/listinfo/redhat-list
>