Network : Bridge over bonding

[Thierry Leurent]

On Friday 23 September 2011 00:12:12 you wrote:
> > > > You probably want to bond eth0 and eth1 into a mode 1 bond, which is
> > > > active/standby based on link status. You then want to make the bond0
> > > > interface a member of bridge0.
> > > 
> > > > From original mail:
> > > BONDING_OPTS="mode=1 primary=eth0 miimon=100"
> > 
> > Just curious, why would one opt for mode 1 over 802.3ad?  If your switch
> > hardware allows link aggregation across chassis I would think that would
> > be the best way to maximize throughput and availability.
> > 
> > Regards
> > etc
> 
> If you are on a single chassis or have OTV support (a logically unified
> chassis), by all means, do 802.3ad :)

Thanks for your help.
Now it's work