[rhn-users] RHEL 3.0 and Broadcom BCM5704
Charith Perera
cperera at intertechmedia.com
Tue Jan 11 15:38:32 UTC 2005
Here's the output from ethtool:
Settings for eth0:
Supported ports: [ MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Current message level: 0x000000ff (255)
Link detected: yes
Output from mii-tool
eth0: negotiated 100baseTx-FD flow-control, link ok
eth1: no link
Charith.
> I am using Dell 1750 RHEL3.0 and it uses the tg3 driver and ethtool
> indicates 1000Mb/s. I also have a 1750 running RHEL2.1 and it uses the
> BCM5700 driver. I think that you are looking at mii-tool and going on it's
> output. mii-tool will only respond with 100baseTx-FD even if it is GigEth.
> Ethtool will give you the correct response:
> [root at phobos root]# ethtool eth3
> Settings for eth3:
> Supported ports: [ MII ]
> Supported link modes: 10baseT/Half 10baseT/Full
> 100baseT/Half 100baseT/Full
> 1000baseT/Half 1000baseT/Full
> Supports auto-negotiation: Yes
> Advertised link modes: 10baseT/Half 10baseT/Full
> 100baseT/Half 100baseT/Full
> 1000baseT/Half 1000baseT/Full
> Advertised auto-negotiation: Yes
> Speed: 1000Mb/s
> Duplex: Full
> Port: Twisted Pair
> PHYAD: 1
> Transceiver: internal
> Auto-negotiation: on
> Supports Wake-on: g
> Wake-on: d
> Current message level: 0x000000ff (255)
> Link detected: yes
> [root at phobos root]# mii-tool
> eth0: no link
> eth1: no link
> eth2: negotiated 100baseTx-FD, link ok
> eth3: negotiated 100baseTx-FD, link ok
More information about the rhn-users
mailing list