can't set 60hz v refresh rate

[Stuart Sears]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

sean enlightened us with the following gems on 15/10/05 18:31:
> Jiann-Ming Su wrote:
> 
>> On 10/14/05, sean <seandarcy2 at gmail.com> wrote:
>>
>>> I hand edited xorg.conf so that the monitor section has
>>>
>>> VertRefresh   60
>>>
>>>
>>
>>
>> Set both VertRefresh and HorizSync to match your monitor's spec.  For
>> example:
>>
>>   Section "Monitor"
>>           Identifier      "Monitor1"
>>           VendorName      "Dell"
>>           ModelName       "1704FPVt"
>>           HorizSync       30-81
>>           VertRefresh     56-76
>>           Option          "DPMS"
>>   EndSection
>>
>> X will figure out what the refresh rate should be.
>>
> 
> Yes. That's the problem. It's choosing 75hz, while i want 60. And yes,
> of course, I have the horizsync set. In any event, in your conf it
> doesn't matter because dpms is set.
> 
> X is choosing the *wrong* refresh rate. How do I specify it?
> 
> sean
> 
have you tried
VertRefresh 60.0 - 60.0
...works for my monitor (17" TFT)
I think it requires a range rather than a  single setting

Regards

Stuart
- --
Stuart Sears RHCE RHCX
/* This card is _fucking_ hot... */
        linux-2.6.6/drivers/net/sunhme.c
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org

iD8DBQFDUVKtamPtx1brPQ4RAq0GAJ94/Q/+DmWR+hHuLiNiRmDU9pUTQwCfdg+j
l8h4M4YyC0RC3HEnu0YbyU0=
=oJpJ
-----END PGP SIGNATURE-----