needed help on MINICOM

[Thom Paine]

On 2/1/06, Gowri Satish Adimulam <gowri at bitel.co.kr> wrote:
> Hi ,
> Iam try to use minicom as simple com-port, it is connected to embedded
> system board via RS 232 cable.
>
>
> in minicom ->serial port setup i have set as
>
> ttyS3,
> baud rate 57600 8n1 which in acordance with embedded system.
>

Are you sure you are using com4 on your PC? I would think com1 or 2
would be the onboard ports. /dev/ttyS0 or /dev/ttyS1.

At the minicom screen try an atz first to reset the modem. If you have
the right port you should get back an OK.

--
-=/>Thom