needed help on MINICOM

[Mike McCarty]

Thom Paine wrote:
> On 2/1/06, Gowri Satish Adimulam <gowri at bitel.co.kr> wrote:
> 
>>Hi ,
>>Iam try to use minicom as simple com-port, it is connected to embedded
>>system board via RS 232 cable.
>>
>>
>>in minicom ->serial port setup i have set as
>>
>>ttyS3,
>>baud rate 57600 8n1 which in acordance with embedded system.
>>
> 
> 
> Are you sure you are using com4 on your PC? I would think com1 or 2
> would be the onboard ports. /dev/ttyS0 or /dev/ttyS1.
> 
> At the minicom screen try an atz first to reset the modem. If you have
> the right port you should get back an OK.

He said he had a direct cable connection to an embedded device.
Why would he expect "OK", as from a modem?

Mike
-- 
p="p=%c%s%c;main(){printf(p,34,p,34);}";main(){printf(p,34,p,34);}
This message made from 100% recycled bits.
You have found the bank of Larn.
I can explain it for you, but I can't understand it for you.
I speak only for myself, and I am unanimous in that!