needed help on MINICOM
Mike McCarty
mike.mccarty at sbcglobal.net
Thu Feb 2 05:20:49 UTC 2006
Gowri Satish Adimulam wrote:
> Hi ,
> Iam try to use minicom as simple com-port, it is connected to embedded
> system board via RS 232 cable.
>
>
> in minicom ->serial port setup i have set as
>
> ttyS3,
> baud rate 57600 8n1 which in acordance with embedded system.
>
>
>
> When my embedded systme boots up , there should be some messages
> displayed on my com port , but unfortunately its not happening.
>
> i have verified the same setup in windows using hyperterminal it is
> working fine.
>
> do i need to do any thing more in the setup.
>
> Thanks in Advance.
You may have permission problems. Are you running minicom as root?
If not, then what are the permissions on /dev/ttyS3?
Mike
--
p="p=%c%s%c;main(){printf(p,34,p,34);}";main(){printf(p,34,p,34);}
This message made from 100% recycled bits.
You have found the bank of Larn.
I can explain it for you, but I can't understand it for you.
I speak only for myself, and I am unanimous in that!
More information about the fedora-list
mailing list