[Fedora-livecd-list] Revisor: Cannot setup installation target. Aborting.

[Lars Bjørndal]

Lars Bjørndal <lars.bjorndal at broadpark.no> writes:

> On søn, aug 26, 2007 at 04:57:18 +0200, Jeroen van Meeuwen wrote:
>> Lars Bjørndal wrote:
>> > On søn, aug 26, 2007 at 12:54:05 +0200, Jeroen van Meeuwen wrote:
>> >> I didn't get this error running from either GIT or revisor-2.0.4.3-1rc1 
>> >> (soon to land in the development repo). Can you reproduce from the 
>> >> latest GIT version?
>> > 
>> > Yes, I can. I did a new GIT install today, and I got the same error
>> > message. Do you need my config files etc.?
>> > 
>> > I use some files from my own repo, could that be a problem? What does
>> > the error message actually indicate?
>> > 
>> > Lars
>> > 
>> 
>> Setting up the installation target is merely providing a loopmounted
>> ext3 filesystem. You could check if the loopmount succeeds with commands
>> mount and losetup -a. As I see it the debug verbosity should be raised
>> because we can now not see what exactly goes wrong.
>
> Output from mount, after aborting, is:
>
> /dev/mapper/VolGroup00-LogVol00 on / type ext3 (rw)
> /dev/proc on /proc type proc (rw)
> /dev/sys on /sys type sysfs (rw)
> /dev/devpts on /dev/pts type devpts (rw,gid=5,mode=620)
> /dev/sda1 on /boot type ext3 (rw)
> /dev/shm on /dev/shm type tmpfs (rw)
> none on /proc/sys/fs/binfmt_misc type binfmt_misc (rw)
> /dev/loop0 on / type ext3 (rw)
>
> - losetup -a
> /dev/loop0: [fd00]:97928 (/var/tmp/revisor-livecd/data/os.img)

Hello!

What could I do to go on solving this problem, do you think?

Lars