[katello-devel] Katello 1.2 Release Candidate

[Mike McCune]

this is correct, I tested the clean install and it works fine, see:

https://pad-katello.rhcloud.com/p/katello-1.2rc1-testing


On 12/10/2012 05:44 PM, Eric D Helms wrote:
> The Ruport RPM has been updated in the 1.2 repositories to remove a
> dependency on fastercsv in the gemspec on Ruby > 1.9 systems.  This
> means that on Fedora 17 systems, Katello should install properly, and as
> long as the following are run (due to SElinux issues with the F17 install):
>
> setenforce 0
> service iptables stop
>
>
> On Mon, Dec 10, 2012 at 11:58 AM, Miroslav Suchý <msuchy at redhat.com
> <mailto:msuchy at redhat.com>> wrote:
>
>     On 12/10/2012 04:01 PM, Eric Helms wrote:
>
>         I got past this error once I manually yum installed
>         rubygem-fastercsv,
>         and after looking over the changelog for Ruport, fastercsv looks
>         like it
>         was not included as a dependency for ruby > 1.9.  Mirek can you
>         speak to
>         this as it looks like you added this?
>
>
>     fastercsv should not be needed. And if you install it using steps
>     documented on our wiki, it is not required.
>
>     If you are using devel setup and you have fastercsv in some Gemfile,
>     it should be removed. Of course only on F17. It should be preserved
>     on F16 and EL6.
>
>
>     --
>     Miroslav Suchy
>     Red Hat Systems Management Engineering
>
>     _________________________________________________
>     katello-devel mailing list
>     katello-devel at redhat.com <mailto:katello-devel at redhat.com>
>     https://www.redhat.com/__mailman/listinfo/katello-devel
>     <https://www.redhat.com/mailman/listinfo/katello-devel>
>
>
>
>
> _______________________________________________
> katello-devel mailing list
> katello-devel at redhat.com
> https://www.redhat.com/mailman/listinfo/katello-devel

-- 
Mike McCune
mmccune AT redhat.com
Red Hat Engineering       | Portland, OR
Systems Management        | 650-254-4248