[PATCH] remote: conf: Mention that 'virtproxyd' doesn't require the '--listen' flag

[Peter Krempa]

'virtproxyd' doesn't have the '--listen' parameter and it's enough just
to enable the corresponding option in the config.

The config file is generic for all the daemons and we just omit/adjust
some sections. Adding a separate mechanism to omit the note about the
'--listen' parameter would be overkill so mention explicitly that it's
required only for libvirtd and not virtproxyd.

The section is omitted for other daemons.

Resolves: https://bugzilla.redhat.com/show_bug.cgi?id=2094641
Signed-off-by: Peter Krempa <pkrempa at redhat.com>
---
 src/remote/libvirtd.conf.in | 12 ++++++++----
 1 file changed, 8 insertions(+), 4 deletions(-)

diff --git a/src/remote/libvirtd.conf.in b/src/remote/libvirtd.conf.in
index defe6b83d0..929d3922e9 100644
--- a/src/remote/libvirtd.conf.in
+++ b/src/remote/libvirtd.conf.in
@@ -8,8 +8,10 @@
 #

 # Flag listening for secure TLS connections on the public TCP/IP port.
-# NB, must pass the --listen flag to the @DAEMON_NAME@ process for this to
-# have any effect.
+#
+# To enable listening sockets with the 'libvirtd' daemon it's also required  to
+# pass the --listen flag on the commandline of the daemon.
+# This is not needed with 'virtproxyd'.
 #
 # This setting is not required or honoured if using systemd socket
 # activation.
@@ -21,8 +23,10 @@
 #listen_tls = 0

 # Listen for unencrypted TCP connections on the public TCP/IP port.
-# NB, must pass the --listen flag to the @DAEMON_NAME@ process for this to
-# have any effect.
+#
+# To enable listening sockets with the 'libvirtd' daemon it's also required  to
+# pass the --listen flag on the commandline of the daemon.
+# This is not needed with 'virtproxyd'.
 #
 # This setting is not required or honoured if using systemd socket
 # activation.
-- 
2.36.1