[Linux-cluster] pool_tool -c
Jonathan E Brassow
jbrassow at redhat.com
Fri May 6 21:40:17 UTC 2005
it requires a file describing the layout of the pool you wish to create
- something completely different from cluster.xml or cluster.conf.
This command is one that you would only run once to write labels out to
the devices. Once the labels are written, pool_assemble is used to
assemble them. you can find more information by looking at the various
pool man pages.
an example file might be:
#begin pool config file
poolname foo
subpools 1
subpool 0 0 1 gfs_data
pooldevice 0 0 /dev/sdb
#end pool config file
The above file would write the label onto sdb. a subsequent
pool_assemble would create a device (/dev/pool/foo) composed of
/dev/sdb.
For more information: 'man 5 pool_conf'
brassow
On May 6, 2005, at 3:57 PM, Collier, Tirus wrote:
> Good Day,
>
> Question in regards to running the pool_tool -c utility. What file
> is required when running pool_tool -c utility? Is it reading
> /etc/cluster.xml or /etc/cluster.conf?
>
> Please advise, thanks.
>
> T--
> Linux-cluster mailing list
> Linux-cluster at redhat.com
> http://www.redhat.com/mailman/listinfo/linux-cluster
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: text/enriched
Size: 1361 bytes
Desc: not available
URL: <http://listman.redhat.com/archives/linux-cluster/attachments/20050506/05472f7a/attachment.bin>
More information about the Linux-cluster
mailing list