[Linux-cluster] Plugged out blade from bladecenter chassis - fence_bladecenter failed

[Parvez Shaikh]

Hi all,

I am using RHCS on IBM bladecenter with blade center fencing. I plugged out
a blade from blade center chassis slot and was hoping that failover to
occur. However when I did so, I get following message -

fenced[10240]: agent "fence_bladecenter" reports: Failed: Unable to obtain
correct plug status or plug is not available
fenced[10240]: fence "blade1" failed

Is this supported that if I plug out blade from its slot, then failover
occur without manual intervention? If so, which fencing must I use?

Thanks,
Parvez
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://listman.redhat.com/archives/linux-cluster/attachments/20110427/e25e7e4d/attachment.htm>