eth0 fails
Jason Pinkney
j-pinkney at onu.edu
Mon Sep 18 17:04:54 UTC 2006
Hi,
I just installed FC5 on a Dell PC.
When it boots up, it fails to find an
IP address for eth0, even though it is
connected to the network via ethernet cable.
Once it is booted, I can start up the same
eth0 device easily (using e.g., the Network
Device Control gui). The device specifies
to use DHCP rather than explicitly defining
netmasks and such.
How can I get the eth0 to start during
boot? (Where could the problem be?)
thanks,
Jason
More information about the Redhat-install-list
mailing list